| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Mod_gnutls is a TLS module for Apache HTTPD based on GnuTLS. Prior to version 0.13.0, code for client certificate verification did not check the key purpose as set in the Extended Key Usage extension. An attacker with access to the private key for a valid certificate issued by a CA trusted for TLS client authentication but designated for a different purpose could have used that certificate to improperly access resources requiring TLS client authentication. Server configurations that do not use client certificates (`GnuTLSClientVerify ignore`, the default) are not affected. The problem has been fixed in version 0.13.0 by rewriting certificate verification to use `gnutls_certificate_verify_peers()`, and requiring key purpose id-kp-clientAuth (also known as `tls_www_client` in GnuTLS) by default if the Extended Key Usage extension is present. The new `GnuTLSClientKeyPurpose` option allows overriding the expected key purpose if needed (please see the manual for details). Behavior for certificates without an Extended Key Usage extension is unchanged. If dedicated (sub-)CAs are used for issuing TLS client certificates only (not for any other purposes) the issue has no practical impact. |
| A vulnerability was identified in Tenda AC8 16.03.50.11. Affected by this issue is the function check_is_ipv6 of the component IPv6 Handler. The manipulation leads to reliance on ip address for authentication. It is possible to initiate the attack remotely. The exploit is publicly available and might be used. |
| The GL-iNet Comet (GL-RM1) KVM connects to a GL-iNet site during boot-up to provision client and CA certificates. The GL-RM1 does not verify certificates used for this connection, allowing an attacker-in-the-middle to serve invalid client and CA certificates. The GL-RM1 will attempt to use the invalid certificates and fail to connect to the legitimate GL-iNet KVM cloud service. |
| Improper verification of cryptographic signature in Smart Switch prior to version 3.7.69.15 allows remote attackers to potentially bypass authentication. |
| A vulnerability was detected in Shenzhen HCC Technology MPOS M6 PLUS 1V.31-N. Affected by this issue is some unknown functionality of the component Bluetooth Handler. Performing a manipulation results in authentication bypass by capture-replay. The attack must originate from the local network. The attack is considered to have high complexity. The exploitation is known to be difficult. The vendor was contacted early about this disclosure but did not respond in any way. |
| A vulnerability was found in HybridAuth up to 3.12.2. This issue affects some unknown processing of the file src/HttpClient/Curl.php of the component SSL Handler. The manipulation of the argument curlOptions results in improper certificate validation. The attack can be launched remotely. This attack is characterized by high complexity. The exploitability is assessed as difficult. The project was informed of the problem early through an issue report but has not responded yet. |
| Improper Input Validation vulnerability.
This issue affects Apache Tomcat: from 11.0.0-M1 through 11.0.14, from 10.1.0-M1 through 10.1.49, from 9.0.0-M1 through 9.0.112.
The following versions were EOL at the time the CVE was created but are
known to be affected: 8.5.0 through 8.5.100. Older EOL versions are not affected.
Tomcat did not validate that the host name provided via the SNI
extension was the same as the host name provided in the HTTP host header
field. If Tomcat was configured with more than one virtual host and the
TLS configuration for one of those hosts did not require client
certificate authentication but another one did, it was possible for a
client to bypass the client certificate authentication by sending
different host names in the SNI extension and the HTTP host header field.
The vulnerability only applies if client certificate authentication is
only enforced at the Connector. It does not apply if client certificate
authentication is enforced at the web application.
Users are recommended to upgrade to version 11.0.15 or later, 10.1.50 or later or 9.0.113 or later, which fix the issue. |
| Microsoft Edge (Chromium-based) for Android Spoofing Vulnerability |
| OpenClaw versions prior to 2026.2.26 contain a metadata spoofing vulnerability where reconnect platform and deviceFamily fields are accepted from the client without being bound into the device-auth signature. An attacker with a paired node identity on the trusted network can spoof reconnect metadata to bypass platform-based node command policies and gain access to restricted commands. |
| OpenClaw versions prior to 2026.2.23 contain a vulnerability in Twilio webhook event deduplication where normalized event IDs are randomized per parse, allowing replay events to bypass manager dedupe checks. Attackers can replay Twilio webhook events to trigger duplicate or stale call-state transitions, potentially causing incorrect call handling and state corruption. |
| OpenClaw versions prior to 2026.2.21 incorrectly apply tokenless Tailscale header authentication to HTTP gateway routes, allowing bypass of token and password requirements. Attackers on trusted networks can exploit this misconfiguration to access HTTP gateway routes without proper authentication credentials. |
| WebCTRL systems that communicate over BACnet inherit the protocol's lack
of network layer authentication. WebCTRL does not implement additional
validation of BACnet traffic so an attacker with network access could
spoof BACnet packets directed at either the WebCTRL server or associated
AutomatedLogic controllers. Spoofed packets may be processed as
legitimate. |
| Improper certificate validation in the PAM propagation WinRM connections
allows a network attacker to perform a man-in-the-middle attack via
disabled TLS certificate verification. |
| JumpServer is an open source bastion host and an operation and maintenance security audit system. Prior to v4.10.16-lts, JumpServer improperly validates certificates in the Custom SMS API Client. When JumpServer sends MFA/OTP codes via Custom SMS API, an attacker can intercept the request and capture the verification code BEFORE it reaches the user's phone. This vulnerability is fixed in v4.10.16-lts. |
| cpp-httplib is a C++11 single-file header-only cross platform HTTP/HTTPS library. Prior to 0.37.2, when a cpp-httplib client is configured with a proxy and set_follow_location(true), any HTTPS redirect it follows will have TLS certificate and hostname verification silently disabled on the new connection. The client will accept any certificate presented by the redirect target — expired, self-signed, or forged — without raising an error or notifying the application. A network attacker in a position to return a redirect response can fully intercept the follow-up HTTPS connection, including any credentials or session tokens in flight. This vulnerability is fixed in 0.37.2. |
| Authentication bypass by capture-replay vulnerability in ABB AWIN GW100 rev.2, ABB AWIN GW120.This issue affects AWIN GW100 rev.2: 2.0-0, 2.0-1; AWIN GW120: 1.2-0, 1.2-1. |
| wpDiscuz before 7.6.47 contains a vote manipulation vulnerability that allows attackers to manipulate comment votes by obtaining fresh nonces and bypassing rate limiting through client-controlled headers. Attackers can vary User-Agent headers to reset rate limits, request nonces from the unauthenticated wpdGetNonce endpoint, and vote multiple times using IP rotation or reverse proxy header manipulation. |
| Supabase Auth is a JWT based API for managing users and issuing JWT tokens. Prior to 2.185.0, a vulnerability has been identified that allows an attacker to issue sessions for arbitrary users using specially crafted ID tokens when the Apple or Azure providers are enabled. The attacker issues a valid, asymmetrically signed ID token from their issuer for each victim email address, which then is sent to the Supabase Auth token endpoint using the ID token flow. If the ID token is OIDC compliant, the Auth server would validate it against the attacker-controlled issuer and link the existing OIDC identity (Apple or Azure) of the victim to an additional OIDC identity based on the ID token contents. The Auth server would then issue a valid user session (access and refresh tokens) at the AAL1 level to the attacker. This vulnerability is fixed in 2.185.0. |
| Unity Catalog is an open, multi-modal Catalog for data and AI. In 0.4.0 and earlier, a critical authentication bypass vulnerability exists in the Unity Catalog token exchange endpoint (/api/1.0/unity-control/auth/tokens). The endpoint extracts the issuer (iss) claim from incoming JWTs and uses it to dynamically fetch the JWKS endpoint for signature validation without validating that the issuer is a trusted identity provider. |
| H3 is a minimal H(TTP) framework. Versions 2.0.0-0 through 2.0.1-rc.14 contain a Host header spoofing vulnerability in the NodeRequestUrl (which extends FastURL) which allows middleware bypass. When event.url, event.url.hostname, or event.url._url is accessed, such as in a logging middleware, the _url getter constructs a URL from untrusted data, including the user-controlled Host header. Because H3's router resolves the route handler before middleware runs, an attacker can supply a crafted Host header (e.g., Host: localhost:3000/abchehe?) to make the middleware path check fail while the route handler still matches, effectively bypassing authentication or authorization middleware. This affects any application built on H3 (including Nitro/Nuxt) that accesses event.url properties in middleware guarding sensitive routes. The issue requires an immediate fix to prevent FastURL.href from being constructed with unsanitized, attacker-controlled input. Version 2.0.1-rc.15 contains a patch for this issue. |
